Mushroom Valves and Washers

NewMushroom2015

Mushroom Valves and Washers

Replacing the Mushroom Valve & Washer

The Mushroom Valve is specifically designed to prevent water flowing out of the reservoir whilst filling. Should a replacement Mushroom Valve or Washer be required, please follow the steps below:

  1. Remove the reservoir from the Propulse®
  2. Remove the old Mushroom Valve from the reservoir and discard
  3. Insert a new Mushroom Valve into the reservoir
  4. Remove the rubber Washer from the underside of the tank plug hole and discard
  5. Insert a new rubber Washer into the lip on the underside of the tank plug hole
  6. Return the reservoir to the machine

N.B.

  • When the mushroom valve is fitted correctly, it should lift slightly with the tension of your finger, when pressed.
  • Be careful when changing the valves and washers, as any damage to either will cause the tank to leak.
  • Be sure to check the valves and washers prior to each use, as they do wear through normal use and may need changing – this will help prevent possible damage to the water inlet valve.
  • Customers who ordered this product, also ordered: